Scope rings for Blaser base

This collection contains scope rings for rifles with a Blaser mounting interface. JK-N makes them from steel in the Czech Republic, with a black anti-reflective finish. You configure the rings on the product page:

• Diameter: 1 inch (25.4 mm), 30 mm or 34 mm, by the main tube of your scope. 30 mm is the most common.
• Height: low, medium or high.
• Base length: short (114.2 mm) or long (139.2 mm). Both fit any Blaser interface.

Ring height

Choose rings that put the scope as low as possible. The objective lens must stay clear of the barrel. A larger objective lens usually needs higher rings.

See 1 inch Blaser scope rings [25.4mm], 30 mm Blaser scope rings and 34 mm Blaser scope rings. To use Picatinny rings on a Blaser base, see Picatinny adapters for Blaser base.

Frequently asked questions

Short or long base?

Both fit any Blaser interface. A long base gives you more room to position the scope.

Which height should I choose?

The lowest height at which the objective lens stays clear of the barrel. A larger objective lens usually needs higher rings.